Our services
How We Can Help?
Step 1
Drill a 1 inch/25mm hole centred on your marked position
Step 2
Assemble the GeeFix wall anchor as shown above by threading the supplied installation cord through the round wall plug, the curved backplate, and back through the wall plug.
Step 3
While holding onto the cord, feed the backplate into the hole and center on the 1″ hole
Step 4
Keeping light tension on the cord slide the wall plug into the hole to align with the holes on the backplate
Step 5
Keeping firm tension on the cord, screw the large screw into the centre hole until the GeeFix becomes firm, but do not overtighten. Keeping tension on the cord will keep the backplate in place during installation
Step 6
Pull out the cord but do not discard. You can reuse the same cord on additional GeeFix installations.
Step 7
Insert the 2 smaller screws on either side of the large screw and tighten until the GeeFix is firmly secured but do not overtighten.
Step 8
Remove the center screw
Step 9
Now that your GeeFix fixing is installed, you can either use the center screw to fix your item, or use your own mounting hardware in its place.